Check whether the pliers or chucks used in the woodworking engraving machine are used improperly. At the same time, the wear of the pliers or chucks of the engraving machine will also lead to the misalignment of the carved objects. If the pliers or chuck are too tight, the moment the cutter head touches the engraving will also cause the product to pop out.
2. For those irregularly shaped sculptures, they seem to be tightly fixed on the surface, and will shake back and forth under pressure. At this point, try to put some objects under the object to increase friction. The other is to preserve the packaging of items. Although the object is irregular, the package it carries may be very regular and easy to fix. With a small belt, irregularly shaped objects are easily fixed. Or try to fix regular parts with tools and discard irregular parts.
3. If the downward pressure of the carved object is very large, please consider whether you need to use a tapered nose. In the engraving process of the engraving machine, if the pressure of the diamond head is too large, the pressure on the side of the tool will cause the movement of the engraving object. If an incorrect diamond knife is used, it will cause the same problem. A 90-degree or 100-degree diamond knife will penetrate the material and move the material while carving.
4. Because woodworking engraving machines are often equipped with multi-functional pliers or chucks, and are made of iron, it is easy to cause damage to the sculptures or make them fall off during the carving process, so choose some rubber caps or rubber tubes to fix the sculptures. helpful.
5. When engraving plastic patterns, you can paste the transfer tape on the back of the object to be engraved, spray liquid spray glue on the side of the tape, and then paste it on the disposable surface, avoid using double-sided tape, leaving a hard-to-clean surface . Because the conveyor belt is easy to peel and clean. Using special engraving tape, one side is more sticky than the other, so you can move or replace the board at will.
After the above introduction, I believe everyone knows some issues that need to be paid attention to in the processing of materials when using woodworking engraving machines. It is recommended that users should pay attention to the above points when operating to ensure that accuracy can be ensured and improved when carving materials.
