LD CNC Equipment Company
Tool magazine：machine tool has the necessary correct device, and it must be carefully checked several times after the device. If the device is unqualified, it will be turned on and used, it will cause damage or damage to them, reducing their life. In severe cases, accidents may occur.
The machine tools are not cleaned: especially the scraps inside. No matter how small the scraps are not cleaned up in time, it will increase the damage rate of the saw blade and consume too fast. During the conflict, the tools of the stone table machining center will heat up, forming a vicious circle. The saw load of the CNC cutting machine is increased, which reduces its life.
The machine tool must be handled with care: to avoid accidentally falling on the ground and bumping and bumps and potholes, the surface of the saw tool of the CNC cutting machine is not lubricated enough, and the conflict force is added to increase the loss of the machine and the loss of the saw blade.
One-time operation time is too long: In order to speed up production, the daily operation may exceed 12 hours, or even the machine can operate 24 hours a day. In this case, the load will increase when the stone table top machining center is cut, causing conflicts to heat up , The physical properties change, resulting in rapid wear.
The above is the reason why the tool wear of stone table machining center is too fast. The stone tool plays a vital role in the work of the stone cnc machine. Only in this way can we ensure good work efficiency and stable work quality.
