Home > Exhibition > Content
Considerations for using laser engraving machine
Mar 03, 2017

1. When auto focal length is used, pay attention to the automatic focus rods must be fastened or table top to the laser.

2. Laser engraving machines at work, prohibition of the boot lid.

3. When opened and smoke, smoke blowing equipment.

4. Processing of wood, paper, must pay attention to the processing speed in order to avoid fire.

5. Early users of irregular red positioning before processing.

6. Processing of thin wood, volatile material, to adjust the amplitude of water more than small 1mm.

7. When cutting, artifacts from the table you want to use more than 2 cm.

8. Reflecting lenses and focal length lens cleaning: two-finger pinch reflex lens. Another hand holding lens cleaning paper clean the lens of the camera.

9. Often carving file, high resolution should be adopted, engraving points when Chen, a bit lower resolution you select.

Copyright © Jinan Lingdiao Machinery Equipment Co.,Ltd All Rights Reserved.Tel: +86-18363086960